Becker CentronicPLUS SWC541 PLUS Notice De Montage Et D'utilisation page 26

manual / automatic
You can display and select the "Manual" or "Automatic" setting by pressing the
STOP button. Only manual drive commands and emergency signals can be
performed with the "Manual" setting. In addition, automatic drive commands
are also performed in the "Automatic" setting. The automatic functions are not
interrupted if a manual drive command is carried out when in automatic mode.
3s
5s
Identification of the hand-held transmitter
A colour can be assigned to the LED ring of the hand-held transmitter by
pressing the function button to make the device easier to identify. The stored
colour can be displayed by briefly pressing the function button. If the function
button is pressed for longer than 3 seconds, the LED ring flashes briefly. The
required colour can now be set by pressing the
available: press the function button again for longer than 3 seconds to store
the colour currently selected.
Battery status
26 - en
Press the STOP button for 3 seconds to display
the current status.
Automatic The LED ring lights up green.
mode:
Manual mode: The LED ring lights up red.
Different The LED ring lights up yellow.
modes:
You can toggle between manual and automatic
mode by pressing the STOP button for 5 seconds.
Battery status low
LED ring flashes yellow 4 times following normal
feedback.
Battery status empty
LED ring flashes red 4 times following normal
feedback.
or button. 9 colours are