Becker CentronicPLUS SWC541 PLUS Notice De Montage Et D'utilisation page 23

The transmitter described in these instructions must only be used indoors for
the operation of radio drives and radio control units that are compatible with
the CentronicPlus.
Attention
A safety-relevant function has been provided for the
thresholds. Setting the threshold values wrongly can cause
damage to the sun protection system. For that reason, set-
ting the threshold values for the safety of your sun protection
system should only be done by – or under the instruction of –
a specialist retailer.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
•
Ensure that the control unit is not installed or operated
close to metal surfaces or magnetic fields.
•
Radio-controlled systems transmitting on the same fre-
quency may cause reception interference.
• Note that the range of the radio signal is limited by legis-
lation as well as by design.
Intended use
23 - en