Publicité
Les langues disponibles
Les langues disponibles
MALFUNCTIONS
Fault table
If you are uncertain about whether your appliance is functioning properly, this does not
automatically mean there is a defect. Make sure to check the points mentioned below in the
table first, or visit our website 'www.Etna.nl' for more information.
Problems with the hob
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
The burner does not burn
evenly.
EN 18
Possible cause
The appliance connection is
leaking.
Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Spark plug dirty/damp.
Burner parts not correctly
installed.
Burner parts dirty/damp.
Main gas supply valve closed. Open the main gas valve.
Fault in gas mains.
Gas bottle or tank is empty.
Wrong type of gas used.
Control knob not pressed in
far enough.
Burner parts not placed
correctly.
Burner parts dirty/damp.
Wrong type of gas used.
Solution
Turn off the main gas tap.
Contact your installer.
Insert the plug into the wall
socket.
Replace the fuse or switch on
the fuse in the fuse box.
Clean/dry the spark plug.
Assemble the burner parts
using the centring ridges.
Clean/dry the burner
components. Make sure that
the outflow holes are open.
Consult you gas supplier.
Connect a new gas bottle or
have the tank refilled.
Check whether the gas used
is suitable for the appliance.
Contact your installer if it is
not correct.
Keep the control knob
pressed in far enough
between full and low. This
can take longer the first time
because of the gas supply.
Assemble the burner parts
using the centring ridges.
Clean/dry the burner parts.
Make sure that the outflow
holes are open.
Check whether the gas used
is suitable for the appliance.
Contact your installer if it is
not correct.
Publicité
