Publicité
Les langues disponibles
Les langues disponibles
1
Place the blender jar with the blade unit interface attached on the
motor unit.
The blender can be placed on the motor unit in two positions.
Put the filter in the blender jar.
Make sure that the grooves of the filter fit exactly onto the ribs inside the
blender jar.
Make sure the appliance is plugged in.
Using the filter
1
Put the lid on the blender jar.
Make sure you place the lid on the blender jar in such a way that the drink
can be poured out through the strainer in the lid.
Put the ingredients in the filter.
Cut fruits into smaller pieces and soak dried pulses, such as soy beans,
before putting them in the filter.
Pour water or another liquid (milk, juice, etc.) into the blender jar.
Insert the measuring cup into the hole in the lid.
5
Select a speed or push one of the buttons (see section 'Control
knob'.
Let the appliance run for approx. 60 seconds.
Note: when you are processing a large quantity, we advise you not to put all
the ingredients in the filter at the same time. Start processing a small quantity
and let the appliance run for a few seconds. Then switch the appliance off
and add another small quantity, but do not exceed the top of the sieve mesh.
Repeat this procedure until you have processed all the ingredients. Always keep
the lid on the blender jar during processing.
After using the filter
1
Switch the appliance off and remove the blender jar from the motor
unit.
Pour out the drink via the pouring lip of the blender jar. Make sure
the lid is placed on the blender jar in such a way that the drink can
be poured out through the strainer in the lid.
Do not remove the lid, the measuring cup and the filter.
Always clean the filter immediately after use.
Recipe
Soy milk
,
For this recipe you need the filter.
EnglisH
11
Publicité
