KTM 22101999088C1A Instructions D'installation page 23

Preassembly of upper triple clamp
–
Place the upper triple clamp on the fuel tank.
Guideline
Protect components with a blanket or similar.
–
Center punch tear-off screws
bit.
Guideline
Drilling depth
Bore diameter
Info
Ensure that the ignition lock and the antenna cable
are not damaged.
–
Remove tear-off screws
crew) and take the upper triple clamp off of the ignition
lock.
Guideline
502857-01
Torx bit
–
Remove screws
from the original triple clamp.
Guideline
Keep the position in mind.
–
Remove ignition lock cover on top
502858-01
–
Position handlebar supports
A
position
(included).
Info
Mount the left and right handlebar supports in the
same position.
–
Mount and tighten screws
Guideline
Screw, handle-
bar support
–
Mount ignition lock cover on top
502854-01
bo
and drill them with a drill
7 mm (0.28 in)
3.5 mm (0.138 in)
bo
with tool (drive bit in and uns-
T20
bp
along with handlebar supports
br
.
bq
in required
B C
, or on upper triple clamp
bp
.
M10x35 45 Nm (33.2 lbf ft)
br
.
ASSEMBLY 5
bq
1
Loctite ® 243™
9