5 ASSEMBLY
5.1
8
Assembly
Info
Assembly at an authorized specialist workshop is recommended.
502855-01
502856-01
Preliminary work
–
Raise the motorcycle using a work stand (center type, see
repair manual).
–
Place a load on the rear of the vehicle.
The front wheel is not in contact with the ground.
–
Remove the front fender (see Owner's Manual/repair manual).
–
Remove the fork legs (see repair manual).
–
Remove the lower triple clamp (see repair manual).
Preassembly of lower triple clamp
–
Mount seal ring retainer
2
clamp
(included).
–
Grease lower bearing
and press in all the way using a suitable tool.
Long-life grease
–
Mount lower steering head bearing
–
9
Remove screws
to replace handlebar stops
Guideline
Screw, handlebar
stop
bm
(included) on bottom triple
bn
(steering head bearing included)
bn
(included).
8
M6
10 Nm (7.4 lbf ft)
.