Beurer HK 67 To Go Mode D'emploi page 17

8. What if there are problems?
Problem
The LED display of the On/Off button (3)
on the heat pad (2) and the white LED
display on the powerbank (1) do not light
up when:
– the powerbank is connected to the he­
ating pad and
– the On/Off button has been pressed.
The LED display of the On/Off button (3)
on the heat pad (2) and the white LED
display on the powerbank (1) do not light
up when:
– the fully charged powerbank is con­
nected to the heating pad and
– the On/Off button has been pressed.
9. Technical data
Powerbank:
Operating temperature: 0 to +45°C
Storage temperature: −10°C to +45°C
Recommended storage temperature: −10°C to +25°C
For technical data, see the type plate label on the heating pad and on the powerbank.
10. Replacement parts
You can obtain the following replacement parts directly from Customer Services:
• Powerbank (item no.163.296)
• Charging cable (item no. 163.297)
• Extension strap (item no. 163.298)
USB is a registered trademark of USB Implementers Forum Inc.
®
Cause
The powerbank has been fully run
down.
There was a SAFETY SWITCH­OFF
due to an error in the heating pad.
The heating pad or the powerbank
is faulty.
17
Solution
Charge the powerbank.
Allow the heating pad to
cool down to room tempe­
rature and switch on again.
Send the heating pad and
the powerbank for servicing.