Beurer HK 67 To Go Mode D'emploi page 13

• When using a USB mains part, the socket used must always be easily
accessible, so that the USB mains part can be disconnected from the
socket quickly in a hazardous situation. For more information, please
see the instructions for use of the USB part.
• Risk of explosion! Incorrect handling of batteries can lead to fire,
explosions, leakage of hazardous substances or other hazardous situ­
ations! Do not throw the powerbank into fire, as the integrated battery
could explode.
• Do not disassemble, split or crush the rechargeable batteries.
• Only use chargers specified in the instructions for use.
• Batteries must be charged correctly prior to use. The instructions
from the manufacturer and the specifications in these instructions for
use regarding correct charging must be observed at all times.
• Always observe the notes on operation (section 4), cleaning and
maintenance (section 5) and storage (section 6).
• If you should have any questions about using our devices, please
contact our Customer Services department.
3. Intended use
IMPORTANT
This heating pad is only designed to warm up the human body.
This heating pad is suitable for personal use only, not for medical or commercial purposes.
4. Operation
4.1 Safety
IMPORTANT
The heating pad is fitted with a SAFETY SWITCH­OFF. The safety system prevents overheat­
ing of the heating pad through automatic switch­off in the event of an error. Once the SAFETY
SWITCH­OFF has taken place, the On/Off button on the heat pad (3) and the white LED display
on the powerbank (1) that is shown when switched on remains illuminated. After cooling, the
heat pad switches on again automatically.
4.2 Charging the powerbank
IMPORTANT
Before you begin charging the powerbank (1), please note the information in section 2 "Important
information".
The powerbank must be charged fully prior to initial use or if the device has not been used for a long
period. If the powerbank is completely run down, the charging process will take approx. 4,5 hours
until it is fully charged again. To charge the powerbank fully, proceed as follows:
– Insert the charging cable (5) provided into the connection socket of the powerbank.
– Connect the other end of the charging cable to a USB charger via the USB port (USB charger with 5V / 1A
SELV in accordance with the requirements of IEC/EN 60335, not included). Whilst charging, the LED display
on the powerbank flashes white.
13