Miele PFD 400 Schéma D'installation page 19

Water connection
Water inlet
The dishwasher must only be connected to fully vented pipework.
A brief increase in the water pressure can damage components of
the dishwasher.
The quality of the incoming water must correspond to the drinking wa-
ter specification of the country in which the dishwasher is being oper-
ated.
The dishwasher must be connected to the water supply in strict ac-
cordance with current local and national water authority regulations.
The dishwasher can be connected to cold or hot water
hot water is not available, the two water inlet hoses (for cold and hot
water) must be connected to the cold water supply via a Y-piece. The
Y-piece must be connected after the non-return valve.
The stopcocks should remain accessible once the dishwasher has
been installed so that the water supply can be shut off whenever the
appliance is not in use.
1) PFD 400, PFD 401 U 125 Edition:
connection to cold or hot water with a water inlet hose
en - Installation notes
1)
supplies. If
19