Télécharger Imprimer la page

Bimar THE WALL PTC-3010R Notice D'instructions page 17

Publicité

Les langues disponibles

Les langues disponibles

• The heater must only be used if secured to a wall: the wall must be flat,
smooth, very stable (as the appliance could tip over) and heat
resistant. The heater must be positioned in a way that: -The air exit grill
has a minimum of free space of 100 cm., while to the sides, the free
space must be at least 40 cm.; -The intake part beneath the cover "B"
must be free from obstacles (covers, curtains, etc.) which could limit
the air inflow causing appliance overheating or damage; -It is well-
removed from other sources of heat; -Far away from baths or showers
to prevent water droplets or steam from affecting it.
• Position the fan heater far from other sources of heat, inflammable
materials (curtains, carpets, etc.), inflammable gases or explosive
materials (spray cans) and from materials that can deform on exposure
to heat.
• If the appliance is fitted to a wall, the same must be made of masonry
and/ or of heat-resistant material (not of wood or synthetic material
which rapidly heats up), care should be taken not to fit panels where
water pipes or electrical wiring might be embedded in the walls; follow
the indications below for installation:
- The heater must be installed at
least 1,8 m above the floor; fit
using the two "lock hole slots" in
the rear panel: make two holes in
wall 40,5cm. apart, at a height of at
least 200 cm. from the floor and
perfectly
expansion wall anchors into the
same and screw, diameter screws
suitable for the slots (see fig. 1)
• Warning: don't use wet hand touch the working machine and don't
cover the wind outlet and inlet.
• Before each use, verify that the heater is in good condition and that
the electrical cord is not damaged: in the case of doubt, ask for
professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in
contact with hot parts or sharp edges, nor wrapped around the device
or twisted.
• The power socket must be easy to reach so the plug can be removed
quickly in case of emergency.
• Make sure that the fan heater is working correctly: if not, turn the
heater off and have it checked by professionally qualified personnel.
horizontal;
insert
17

Publicité

loading

Ce manuel est également adapté pour:

Hp100