|
DC Power Connection
Inspect power cable before each use! Damage to the outer jacket of the
cable that exposes wiring requires replacement of the power cable.
The power cable terminates in black and red clamps.
1.
Connect the black (negative) clamp to the negative post of the DC
power source first.
2.
Connect the red (positive) clamp to the positive post last.
Clamps should be disconnected in reverse order.
Pump Operation
CAUTION
Your Fill-Rite DEF pump has a 30 minute Duty Cycle. After a 30 minute cycle of continuous operation, turn the pump off for 30 minutes. Failure
to observe this duty cycle can damage the motor in your pump.
CAUTION
DO NOT operate your pump for more than 3 minutes without dispensing fluid. Extended periods of operation without dispensing fluid will
damage the pump.
CAUTION
Before operating your pump, take a moment to make sure everything is ready. Do not proceed until you have verified the following:
•
•
•
•
•
1.
Connect the pump to the appropriate power supply (120VAC =
Wall Receptical / 12V DC = battery or DC power supply).
2.
Turn pump Power Switch to "ON" (I) position.
3.
Remove Nozzle from Nozzle Reservoir and insert Nozzle Spout into
tank or container to be filled.
4.
Squeeze Nozzle Trigger to dispense fluid until the desired amount
has been dispensed.
5.
Release Nozzle Trigger, and return the Nozzle to the Nozzle Reservoir
(be certain reservoir contains sufficient fluid to emerse the nozzle
spout as illustrated in Figure 9c on page 6).
6.
Turn pump off and coil discharge hose onto bracket.
fillrite.com
DF SERIES
Verify the power switch is in the "OFF" position (O)
Verify the water in the nozzle boot is clean and free of debris, and is deep enough to cover the spout
Inspect nozzle spout to make sure it is clean and free of debris, and crystalized DEF
Verify hoses and suction tube connection are clear and free of pinches or other restrictions
Verify there is sufficent DEF in the supply tank to operate the pump
INSTALLATION AND OPERATION MANUAL
1
Black
2
Red
7