AEG RMB954E9VX Manuel De L'utilisateur page 28

28 www.aeg.com
8. To gain access to lower hinge,
drawer will need to be extended.
Unscrew the three lower hinge
screws and slide the hinge inwards
Lift up on door and remove from
bottom hinge.
Lower Hinge Removal
CAUTION
Be sure doors are set aside in
a secure position where they
cannot fall and cause personal
injury, or damage to the doors
or handles.
9. To reinstall doors, reverse procedure.
IMPORTANT
Make sure water line tubing goes
through hole at top of dispenser
pocket. There is also a metal
wrap on the tubing to prevent
damage from the hinge rubbing
against it. This needs to be
fixed back around the tube in
the proper location upon re-
installation (just as long as the
tube is protected from the hinge).
NOTE
When reinserting the water tube
and replacing the top hinge
cover, use care to be sure the
tube does not kink.
Once both doors are in place, ensure
they are aligned with each other and
level (Please see the Installation section
for more details), and replace the top
hinge cover.
12.2 To remove the
MultiSwitch/MultiChill
drawer
1. Fully open drawer.
2. Remove basket from drawer.
3. Unclip harness at front of drawer
and move harness out of the way
of drawer slides.
4. Press liner clips and slide rail past
clips on both sides to fully remove
drawer from cabinet.
5. Reverse the steps to reinstall
the drawer.
12.3 Removing Freezer Drawer
CAUTION
Drawer is heavy. Use caution
when lifting.
1. Open drawer and fully extend.
2. Remove the freezer drawer.
3. Remove the freezer basket.
4. Inside the cabinet, press the two tabs
on both sides to release the sliders.
5. Remove the drawer with brackets
and sliders.
12.4 Re-installing Freezer
Drawer
1. Place drawer with brackets and
sliders inside the cabinet and click
into place.
2. Replace the basket.
Press the
two tabs on
both sides to
release the
sliders
Unclip
Harness
Press the two tabs
on both sides to
release the sliders
Freezer
Drawer
Freezer
Drawer