AEG RMB954E9VX Manuel De L'utilisateur page 21

NOTE
If you need to replace the
device, you must use a new
water inlet.
Installation Procedure
Join Check valve to the tap water line
Adapter
Water Tube
7. Open the locking clips and grab
water coming from the refrigerator.
Remove plastic cap from water inlet
fitting and discard cap. Replace the
connected tubes into the clips and
lock clips back in place to keep the
tubing in the right position.
Plastic
cap
Tap
Check valve
Remove
the cap
from the
inlet tube
¼ inch
water
valve
plastic
tube
Connector to
connect the water
supply line to the
refrigerator tube
D
A
Check
valve
8. Attach check valve (item A) to the
tap water. Place the swivel nut of the
check valve straight onto the male
thread of the tap water. Tighten to
a torque of 3 Nm. Make sure that
the metal ring is correctly seated on
the toothed part of the swivel nut.
Connect the adapter (item B) to
the check valve. Connect the water
supply line (item C) to the adapter
(item B). While holding the other end
of the water supply line in a bucket
or sink, turn on the water supply to
eliminate air and clean the water
supply line. Turn off the water supply.
9. Remove the plastic protector from
the refrigerator tube and connect
the water supply line (item C) to the
refrigerator tube using the connector
(item D) as shown in fig. Make sure
the tubes are inserted completely into
the connector.
10. Turn on the water supply and check
for leaks at the connections. Repeat
leak checks at suitable intervals.
11. After installation of refrigerator and
water line system, select "WATER"
on your control panel and press it for
1-2 minutes to supply water into the
water tank and dispenser water.
ENGLISH 21
Water
supply line
C
B
Adapter to
connect the
check valve