Publicité
Les langues disponibles
Les langues disponibles
the filters may reduce the performance level of the appliance and damage
dishes and utensils.
Cleaning the spray arms
It is necessary to clean the spray arms regularly, otherwise hard water chemicals
will clog the spray arm jets and bearings.
To clean the spray arms, follow the instructions below:
2. To remove the
1. To remove the upper spray
arm,hold the nut in the
centre still and rotate the
spray arm anticlockwise to
remove it
Frost precaution
Please take frost protection measures on the dishwasher in winter. Every time
after washing cycles, please operate as follows:
1. Cut off the electrical power to the dishwasher at the supply source.
2. Turn off the water supply and disconnect the water inlet pipe from the
water valve.
3. Drain the water from the inlet pipe and water valve (Use a pan to gather the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up
water inthe sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the door
slightly open so that moisture and odors are not trapped inside.
94
3. Wash the arms in
lower spray arm,
warm soapy
pull out the spray
Water using a soft
arm upward.
brush.
Replace them after rinsing
them thoroughly.
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or
abrasive cleaning products. Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the interior, use a cloth dampened
with water an a little vinegar, or a cleaning product made specifically for
dishwashers.
When not in use for a long time
It is recommend that you run a wash cycle with the dishwasher empty and then
remove the plug from the mains socket, turn off the water supply and leave the
door of the appliance slightly open. This will help the door seals to last longer
and prevent odors from forming within the appliance.
Moving the appliance
If the appliance must be moved, try to keep it in the vertical position. If absolutely
necessary, it can be positioned on its back.
Cleaning the seals
One of the factors that cause odours to form in the dishwasher is food that
remains trapped in the seals. Periodic cleaning with a damp sponge will prevent
this from occurring.
95
Publicité
