Chamberlain LiftMaster SECURITY+ ELITE Serie Manuel D'utilisation page 28

Using the Remote Control
NOTE: To activate the remote control functions, pull out
the plastic pull tab protruding from the remote control
housing.
This remote control is equipped with a proximity lighting
feature. When moving a hand within close proximity to
the remote control, the LED lights turn on for 3 seconds.
Upon successful activation of a remote control button,
the LED lights will blink rapidly.
Proximity Disable Feature
The remote control will turn off the proximity lighting
feature if the proximity lighting is turned on 10
consecutive times without activation of a button. To
re-enable the proximity lighting, simply press a button.
This function conserves battery life.
To Control the Opener Lights
With 315MHz Security✚
button can be programmed to operate the opener lights
without opening the door.
1. With the door closed, press and hold the remote
button that you want to control the light.
2. Press and hold the Light button on the multi-function
control panel.
3. Press and hold the Lock button on the multi-function
control panel.
4. After the opener lights flash, release all buttons.
Test by pressing the remote push button. The opener
lights should turn on or off but the door should not move.
Troubleshooting
PROBLEM SOLUTION
Check if proximity lighting is
disabled by pressing a button.
Reduced proximity
The Proximity Sensor may be
sensing (does not
oversensitized. Sit remote control
activate by
undisturbed for 60 seconds on a
touching top of
non-metallic surface. This allows
remote control)
the sensor to recalibrate itself.
Replace 3V2450 battery with
same type 3V2450 coin cell.
Replace two 3V2016 batteries
Dim LED lights
with same type 3V2016 coin
cells.
No rapid LED
Replace two 3V2016 batteries
blinking after
with same type 3V2016 coin
pressing a button
cells.
remote controls, a remote push
®
The Remote Control Batteries
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V2032 coin batteries.
• Do NOT recharge, disassemble, heat above 100°C
(212°F) or incinerate.
The 3V2016 lithium batteries for the opener and LED
lights (marked "LED and Opener Battery") should last 5
years. The 3V2450 lithium battery for the proximity
lighting (marked "Proximity Battery") should last 1-2
years.
To replace the batteries,
remove the two screws
and open the remote
control housing. Push the
battery out of the holder
for removal. Insert
replacement batteries
positive side up. Dispose
of old batteries properly.
Replace the batteries with
only 3V2016 or 3V2450
coin cell batteries.
CAUTION: Do not bend spring contact. If bent the
proximity sensor will not work.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
28
Proximity
Battery
LED and
Spring
Opener
Contact
Batteries