Kapro PROLASER ELECTROTA 8991 Manuel D'utilisation page 17

POWER SUPPLY
Rotary Laser
The Prolaser Electrota
®
rechargeable batteries and a battery charger (AC/DC Converter).
Note: A bracket and a set of four regular type C batteries are
also supplied for optional use.
1. Recharge the batteries when the
power indicator on the
control panel starts to flash.
2. Plug the battery charger into a
power source.
3. Insert the plug of the battery
charger into the socket on the laser
level or on the battery pack.
1. Battery charger
2. Bottom of laser
3. Rechargeable batteries
Note: You can charge the rechargeable battery pack inside or
outside of the laser level. The Rotary Laser can be operated
while recharging. It takes approximately seven hours to fully
charge the batteries. Brand new or unused rechargeable
batteries require three recharge / discharge cycles to attain full
capacity.
4. The indicator LED on the battery charger lights steady red
while charging and steady green when fully charged. The
indicator LED will flash if not connected to the batteries.
5. The battery pack can be removed from the Rotary Laser by
unscrewing the locking nut, holding the battery pack in place.
Note: If the laser level is not in use for a long period of time,
remove the battery pack from the battery compartment. This will
prevent leakage or/and corrosion damage.
8991 is supplied with on-board internal
™
17