Publicité
Les langues disponibles
Les langues disponibles
Inclined Plane
The Rotary Laser can be set up to create a single or dual
directional inclined planed at ±5° from the horizontal plane. This
is very helpful for laying inclined concrete surfaces, ensuring run-
off pathways as well as laying water and sewage lines.
1. Set up the Rotary Laser approximately level; the instrument
can compensate for up to ±5° from the horizontal plane.
2. Press the On/Off button. The power indicator will light
up and the laser beam will blink. If the instrument is set
up outside the ±5° limit the manual indicator will blink and
rotation will not begin.
3. The Rotary Laser is ready to work when the laser beam no
longer flashes. The instrument is now level and the laser
head will rotate at 600 rpm.
4. Press the Manual/Automatic button to change the rotating
laser to Manual Mode.
5. Verify that the Manual
indicator is lit.
6. For X direction slope:
Position X axis parallel
to plane requiring slope
setup. Press to raise
X1 and lower X2. Press to raise X2 and lower X1.
For Y direction slope:
Position Y axis parallel to plane requiring slope setup.
Press
to raise Y2 and lower Y1. Press
lower Y2.
10
to raise Y1 and
Publicité
