Publicité
Les langues disponibles
Les langues disponibles
XP SBC RU 520/00.3 06-02-2004 14:09 Pagina 7
All manuals and user guides at all-guides.com
Automatically setting the remote control
If you cannot find the right code for your brand device,
the remote control can automatically search for the right code.
Example of TV:
1
Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU520 emits the 'switch off TV' signal for all models of TV that are
stored in the memory.
•
If the device is a DVD-player or video recorder,
insert a disk or tape and start playback.
2
Then keep keys 1 and 3 on the RU520
pressed simultaneously for three seconds,
until the green light under TV in the selector
window flashes twice and then remains lit.
3
Press the Standby key of the RU520 briefly.
–
The RU520 now starts emitting all known
'TV off ' signals, one by one.
Each time a code is sent, the green light under
TV in the selector window lights up.
4
When your TV switches off (stand-by),
you press the Standby key of the RU520
twice within 1 second, to confirm.
–
The RU520 has now found a code that works
on your TV.
5
Check if you can operate all functions on your TV with the RU520.
•
If this is not the case, you can redo the automatic setting.
The RU520 will then search for a code that perhaps works
better.
–
After the RU520 has run through all the known codes,
the search will stop automatically and the green light will stop flashing.
–
Automatic programming of a TV takes a maximum of 5 minutes. For
VCR/DVD this time is 2 minutes.
Instructions for use
1
2
3
4
5
6
7
8
9
0
SHIFT
TV VCR/ DVD
TV VCR SAT DVD
2x
TV VCR/ DVD
7
Publicité
