5 2 Selecting A Frequency From A Group; 5 3 Scan Function - Monacor JTS R-4/5 Mode D'emploi

FREQ. G-CH ID
1
507.500 1-1
2 ? 508.500 1-2
3 512.000 1-3
×
4 514.125 1-4
×
Fig. 12 Current settings of the receiver sections:
Frequency, Group, CH = channel, ID number for the
REMOSET function,
[13]), = battery status of the transmitter,
status not transferred yet,
2) Call up the frequency setting via the menu
item
1.Frequency
Setup Frequency
507.500 MHz
G:1 CH:1
3) Turn the knob PUSH / CONTROL to set the
frequency in steps of 1 MHz
4) For fine adjustment in steps of 0 025 MHz, press
the knob so that the digits after the decimal
point are highlighted Then turn the knob If
the frequency is identical to the frequency of
a channel in a group, the group and channel
numbers are indicated in the lower line
5) Press the button SETUP to save the frequency
adjusted
4.5.2 Selecting a frequency from a group
The easiest way to operate multiple transmitters
at the same time is to select the frequencies from
one of the 6 groups:
1) Call up setting menu for the receiver section
(see chapter 4 5 1); then call up the group
and channel selections via the menu item
2.Group/Channel
Setup Group
G: 3 CH:18
536.650 MHz
2) Turn the knob PUSH / CONTROL to select
the group
3) Press the knob to highlight the channel num-
ber Then turn the knob to select the channel
The corresponding transmission frequency is
indicated in the lower line
4) Press the button SETUP to save the setting
22
1.Frequency
1 0
2.Group/Channel
2 -2
3.Scan
3 -10
4.Squelch
4 -10
= volume (adjustable with
= battery
?
= no reception
×
:
Fig. 13
:
Fig. 14
4.5.3 Scan function
Before a transmission channel is selected, the
scan function can be used to determine if other
transmission systems are currently transmitting
on the channels of the receiver R-4/5 The chan-
nels already used will be skipped during channel
 
selection
Call up setting menu for the receiver section (see
chapter 4 5 1); then call up the selection menu for
scanning via the menu item
1.All Groups
2.Result List
3.Current Group
4.Return
It is possible to scan the channels of all groups
( table on page 27) (this will take approx
☞
1 minute) or only the channels of one group (this
is faster)
Note: To return to the setting menu, use the menu
item
4.Return
– Scanning all channels –
1) Select the menu item
(fig 15) if it has not been selected yet Then
press the knob PUSH / CONTROL
Scan All Groups
Press Setup or Enter to
start scan.
Press Exit to quit.
2) Press the button SETUP or the knob PUSH /
CONTROL to start scanning The display in-
dicates
Scanning...
time, press the button EXIT
3) After scanning, the free channels are indi-
cated
Result List
G: 1
Open Channel : 12
Group 1 has been selected The lower line indi-
cates the number of free channels, in this case
12 channels In group 1, 14 channels are avail-
able, i e 2 channels are already being used
4) Turn the knob PUSH / CONTROL to select all
6 groups
5) To select a free channel, press the knob so
that the channel number is highlighted Then
turn the knob When the knob is turned, the
channels already used are skipped
3.Scan
Fig. 15
1.All Groups
Fig. 16
%
CH: 2
Fig. 17
To exit at any