1 1 Interconnecting Multiple Receivers; 2 Switching The Receiver On Or Off; Indications On The Display, Volume, Key Lock - Monacor JTS R-4/5 Mode D'emploi

2) Two options are available for routing the mi-
crophone signals received to the audio inputs
of the subsequent unit (e g mixer, amplifier):
– Routing all signals individually: Use the XLR
connections CH1 – CH4 (19)
– Routing all signals mixed: Use the connec-
tions MIXED AF OUTPUT (18)
The output levels can be switched between
line level and microphone level (chapters 4 4
and 4 6 1)
3) For power supply, use the cable provided
to connect the mains jack (14) to a socket
(230 V/ 50 Hz)
Hint: The receiver has a low power consumption
even when it is switched off Therefore disconnect
the mains plug from the socket when the receiver
is not used for a longer period of time
~ 230 V
1. R-4/5
2. R-4/5
3.
. ..
10. R-4/5
Fig. 4 Interconnecting up to ten receivers
Antenna A In MIXED
12V out AF OUTPUT
100mA RF A Out
Freq. Range:
506-542 MHz
Serial No.:
UNBALANCED BALANCED
Antenna A In MIXED
12V out AF OUTPUT
100mA RF A Out
Freq. Range:
506-542 MHz
Serial No.:
UNBALANCED BALANCED
Antenna A In MIXED
12V out AF OUTPUT
100mA RF A Out
Freq. Range:
506-542 MHz
Serial No.:
UNBALANCED BALANCED
4.1.1 Interconnecting multiple receivers
Fig 4 shows interconnection of multiple receivers
R-4 / 5 Only for the first receiver, two antennas
and a mains cable are required The other receiv-
ers are interconnected by means of the cables
supplied Thus, up to ten receivers R-4 / 5 can most
conveniently be interconnected

4.2 Switching the receiver on or off,

indications on the display, volume,
key lock
1) Use the button
The display (3) will show the status of the four
receiver sections (as in fig 1) The following
warning messages may periodically be shown:
No Signal
microphone / pocket transmitter) is switched
off or uses a different transmission frequency
than the receiver (
= The transmitter is muted
Mic.Mut
Low Battery
wireless microphone / transmitter are almost
discharged
Mic 4 Mic 3 Mic 2
CH4 CH3 CH2
AF OUTPUT AF OUTPUT AF OUTPUT
BALANCED BALANCED BALANCED
Mic 8 Mic 7 Mic 6
CH4 CH3 CH2
AF OUTPUT AF OUTPUT AF OUTPUT
BALANCED BALANCED BALANCED
Mic 40 Mic 39 Mic 38
CH4 CH3 CH2
AF OUTPUT AF OUTPUT AF OUTPUT
BALANCED BALANCED BALANCED
(4) to switch on the receiver
= The transmitter (wireless
☞ chapter 4 5)
= The batteries of the
Mic 1
CH1 Antenna B In
12V out
RF B Out 100mA
AF OUTPUT
BALANCED
Mic 5
CH1 Antenna B In
12V out
RF B Out 100mA
AF OUTPUT
BALANCED
Mic 37
CH1 Antenna B In
12V out
RF B Out 100mA
AF OUTPUT
BALANCED
19