Applications; 1 Conformity And Approval; Operation; 1 Connections - Monacor JTS R-4/5 Mode D'emploi

3 if malfunctions occur
In any case the unit must be repaired by skilled
personnel
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug
•
For cleaning only use a dry, soft cloth; never
use chemicals or water
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated or if it is
not repaired in an expert way
If the unit is to be put out of operation
definitely, dispose of the unit in accord-
ance with local regulations

3 Applications

Combined with matching transmitters (wireless
microphones / pocket transmitters with connected
microphone), the receiver R-4 / 5 creates a wireless
audio system which is ideally suited for profes-
sional stage applications The REMOSET
is a most convenient feature for operating the sys-
tem: Simply press a button to transfer the settings
of the receiver, such as transmission frequencies,
to the transmitters via a radio signal
The receiver uses "Diversity" technology: The
signals sent from the wireless microphones or
pocket transmitters are received by two antennas
The signal of the highest quality is then processed
The transmission range depends on local con-
ditions; in open-field conditions, the minimum
range is 100 m
The following transmitters can be combined with
the receiver R-4 / 5:
Model
hand-held wireless microphone with
JSS-4B / 5
dynamic microphone cartridge, cardioid
hand-held wireless microphone with
R-4THA / 5
condenser microphone cartridge, cardiod
pocket transmitter for JTS microphones
R-4TBM / 5
with 4-pole mini XLR plug
18
function
®
Type

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the product R-4 / 5 complies with the directive
2014 / 53 / EU The EU declaration of conformity is
available on the Internet:
www jts-europe com
Restrictions or requirements apply in the fol-
lowing countries:
CZ
IT
The regulations of the country where the product
is operated must always be observed Prior to
operating the product, please contact the MONA-
COR subsidiary or the corresponding authorities
of the respective country Links to the national
authorities can be found via the following Inter-
net address:
www cept org
tECC
tTopics
tOther spectrum topics: SRD Regulations and
indicative list of equipment sub-classes
tEFIS and National Frequency Tables

4 Operation

The unit is designed for installation into a rack
(482 mm /19"); however, it can also be placed
on a table For installation into a rack, 1 RS (rack
space = 44 45 mm) is required

4.1 Connections

Always switch off the receiver before making or
changing any connection
1) Insert the two antennas provided (2) into the
antenna jacks "Antenna A (B) In" (16) and put
them in a vertical position
Hints:
1 To increase the range and the interference re-
sistance, the antenna amplifiers UB-900I can be
inserted The amplifiers are supplied with power
via the antenna jacks of the receiver (chapter 4 4)
2 By means of the antenna cable set RTF-UF20, the
antennas can also be fixed to the front of the
receiver: Insert the jacks of the antenna cables
through the mounting holes (1) and fasten them;
then connect the cables to the antenna jacks (16)
EL FI FR
LT MT PL