Télécharger Imprimer la page

VONROC TL503 Serie Traduction De La Notice Originale page 7

Publicité

Les langues disponibles

Les langues disponibles

lation in the country of use.
• E nsure the ladder is suitable for the task. If
unsure, contact a qualified person for guidance.
• D o not use a damaged or otherwise unsuitable
ladder.
pOSITIONING AND ERECTING THE LADDER
• E nsure the ladder is fully collapsed, all locks are
secured and the ladder is free from contami-
nants before moving to the area of work. Only
erect and close in a safe work area. Do not move
the ladder when erect.
• O nly position and use the ladder on an even, level
and unmoveable base.
• W hen positioning the ladder, take into account
risk of collision with the ladder e.g. from pedes-
trians, vehicles or doors.
• S ecure doors (not fire exits) and windows where
possible in the area.
• I dentify any electrical risks in the work area, such
as overhead lines or other exposed electrical
equipment. This ladder does not offer insulation
or protection from electrical hazards.
• T ake extra care when using electrical equipment,
this ladders conducts electric current. Always
take precautions so that a power cable cannot
become trapped or become caught when using
the ladder. Check beforehand that your tool's
electrical cable is undamaged. Keep the ladder
at least 2m away from non-insulated live electri-
cal equipment.
• T he ladder shall be only be positioned flat on its
feet, not the rungs or steps. Never position or
use the ladder on slippery surfaces (such as ice,
shiny surfaces or significantly contaminated solid
surfaces) unless additional effective measures
are taken to prevent the ladder slipping or ensu-
ring contaminated surfaces are sufficiently clean.
• T he ladder shall be erected at the correct positi-
on, such as the correct angle for a leaning ladder
(angle of inclination approximately 1:4) with the
rungs or treads level (e.g. 1m away from the base
of a wall if extending to climb 4m up).
• A lways position the ladder against a flat, non-fra-
gile surface and secure properly before use e.g.
tied down or with the use of a suitable stability
device.
• T he locking mechanisms for all the extended
rung sections shall be locked before using the
ladder.
• N ever attempt to move or reposition the ladder
www.vonroc.com
from above.
USING THE LADDER
• D o not exceed the maximum total load of
150kg/330lbs for this ladder.
• O nly allow one person to use the ladder at any
time.
• L adders should only be used for light work of
short duration.
• U se non-conductive ladders for unavoidable live
electrical work. This ladder is not suitable for
live electrical work as it is conductive and offers
no protection from electrical hazards.
• N ever erect or use the ladder upside down. The
base should always sit firmly on the ground.
• D o not use the ladder outside in adverse we-
ather conditions, such as strong wind or rain.
• D o not leave an extended ladder unattended.
• T ake precautions against children playing on
the ladder.
• D o not place any tools or other objects on the
rungs and do not hang anything on the ladder
system.
• E quipment carried while using a ladder should
be light and easy to handle.
• F ace the ladder and keep a secure grip when
ascending and descending.
• D o not slide down the stiles of the ladder. Climb
and descend with deliberate movements.
• A lways maintain 3 points of contact with the
ladder at all times e.g. two feet on the same
rung and a hand on the stiles. Use additional
safety equipment if this is not possible.
• M aintain a handhold whilst working from a
ladder or take additional safety precautions if
you cannot.
• D o not overreach; always keep your belt buckle
(navel) inside the stiles and both feet on the
same step/rung throughout the task.
• A void work that imposes a sideways load on
ladders, such as side-on drilling through solid
materials (e.g. brick or concrete).
• I n the leaning ladder position it is not allowed to
climb higher than last metre of the ladder.
• T he user shall put the hands around the stile
when bringing the ladder from extended to
storage position.
• D o not stand on the top four rungs on the lad-
der; this can cause stability issues.
• Do not use the ladder as a bridge.
• L eaning ladders used for access to a higher
EN
7

Publicité

loading