Maintenance And Service - BEAL BRILL CROSSOVER 95/13H Notice D'emploi

Mowing system
43
On the mowing deck, there is a connection for a ½" water
hose coupling.
The mowing system can be cleaned by connecting a water
hose.
During the cleaning process, the grass box or a suitable
accessory must be fitted.
1. Lower the mowing deck to the lowest cutting height.
2. Start the engine - set a medium engine speed.
3. Switch the mowing appliance on.
4. Connect the hose to the connection and turn the water
on.
After a few minutes, the mowing system has been
cleaned.
5. Leave the mowing system to run for a few more minutes
in order to spin the water out.
6. Clean the grass box and leave to dry.

MAINTENANCE AND SERVICE

Maintenance, service and cleaning work may only be carried out when the machine has been turned off and has cooled down
and the ignition key has been removed.
The following tasks may be carried out by the user himself. All the other maintenance, service and upkeep tasks must be carried
out by a qualified service agent.
Check level of engine oil
Change engine oil
Clean the air filter
Replace the air filter
Check the spark plug
Check the brake
Check the tyre pressure
Check mowing blade
Check for loose parts
Check drive belt
Clean the lawn tractor
Clean air intake grille on engine
Clean grass and cuttings from transmission
For hydrostat drive:
Clean ventilator for transmission cooling
Lubrication plan page GB 20
In cases of high load and high temperatures, shorter maintenance intervals than those stated in the table may be necessary.
GB
Checking by a qualified service agent is
necessary:
-
-
-
-
-
-
-
-
-
Before each
After each use
use
GB 19
after impact with an obstacle
if the V-belt is defective
if the engine comes to an immediate standstill
if the brake performance drops
if the blade is bent (do not straighten)
if the drive belt slips
if the blade shaft is bent (do not straighten)
if there is a defect in the blade holder
if there is damage to the transmission.
After 25 hours
After the first 5
of operation
hours
)* see operating instructions of the engine manufacturer
After 50 hours Before each
of operation storage