Setting The Cutting Height - BEAL BRILL CROSSOVER 95/13H Notice D'emploi

Switching the mowing appliance off
Put the mowing appliance switch onto position "0".
•
• The mowing appliance can be switched off both at a standstill and
also during movement.
Attention!
A rotating / slowing blade can cut hands and feet.
Therefore, keep your hands and feet away from the blades.

Setting the cutting height

The blades are raised and lowered with the position lever
39
to the right of the driver's seat.
Six height settings with a cutting height between 30 and 90
mm are possible.
Allow the position lever to engage at the height adjustment
position required.
Adjustment of the cutting height can be done both at a
standstill and also during movement.
Attention:
Set the highest cutting height:
- before switching the cutting appliance on
- when driving without mowing
Driving without traction (pushing)
Attention!
Only with the engine switched off and the blades stationary!
a) For a 5-gear transmission:
1. Put the switch lever into position 0.
2. Release the brake.
b) For a hydrostat drive with hand switching lever:
40a
1. Remove or lift up the grass box.
2. Pull out bypass lever
3. Release the brake.
The lawn tractor can now be pushed without any difficulty.
c) For a hydrostat drive with foot pedal:
40b
1. Remove or lift up the grass box.
2. Push in the bypass lever an engage (downwards).
The lawn tractor can now be pushed without any difficulty.
GB
and engage downwards .
GB 17
Driving and mowing
In order to achieve a tidy mowing result, the traction speed must
be adapted to the state of the lawn.
a) Lever / pedal position for hydrostat drive:
37
- long / thick grass and wet grass: 0 - ¼
- normal grass, weekly cutting: ½ - 2/3
The lever / pedal positions from 2/3 - 1/1 are reserved for
driving without mowing.
b) Lever position for 5-gear transmission:
38
- long / thick grass and wet grass: 1st gear
- normal grass, weekly cutting: 2nd - 3rd gear
4th and 5th gear are reserved for driving without mowing.
In a normal case, the cutting height is about 4-5 cm. This corresponds
to the 2nd/3rd position of the height adjustment. Cut moist or wet grass
with a higher cutting height.
The best thing to do with very long grass is to cut it twice. For the first
cut, set the machine to max. cutting height and set it to the required
height for the second cut.