Broan best K7788 Mode D'emploi page 6

HALOGEN BULBS
This range hood requires two halogen bulbs
(Type T4, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICAL
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Open the cover by prying from the proper
slots. - DO NOT ROTATE. CAUTION:
BULB MAY BE HOT! Fig. 1
2. Replace with a Type T4, 12V, 20W bulb.
Do not touch replacement bulb with bare
hands!
FUSE REPLACEMENT
IF LIGHTS FAIL TO OPERATE, DISCONNECT
THE POWER AT THE SERVICE ENTRANCE.
CHECK THE FUSE AND REPLACE IF
NECESSARY.
1. Remove the decorative flue. Fig. 2
2. Remove the cover from the large
electrical wiring box.
3. Locate the fuse holder. Unscrew its cap
and remove the fuse.
4. Replace the fuse with the same size and
amperage (5x20mm, 4amp, 125volt).
5. Reinstall the electrical box cover and
decorative flue.
6. Reconnect power at the service
entrance.
FUSE
ELECTRICAL BOX
- 6 -
FIG. 1
DECORATIVE FLUE
FIG. 2