Publicité
BoseProfessional.com
Securing the Wiring
Feed the wiring through the gland nut on the bottom of the input panel. Once you are done wiring your
loudspeaker, rotate the gland nut clockwise to seal the wire after attaching the input cover (see Attaching the
Input Panel Cover section). Tighten the gland nut by hand until the wire is held firmly in place, then tighten
the gland nut an additional quarter turn. Do not over-tighten.
CAUTION: If the gland nut is not properly fastened, water could get into the input panel and damage
the loudspeaker.
Attaching the Input Panel Cover
ArenaMatch full-range modules are shipped with the rear input panel cover not installed. Once you've made
input wiring connections, secure the cover over the input panel with the included eight screws.
Note: The input cover can be rotated to support four different orientations. Always be sure the gland nut and
wiring are facing downward.
Installation Guide • ArenaMatch DeltaQ Array Loudspeaker
Specifications
English • 17
Publicité
