EUROM Desset Air 10 Manuel D'utilisation page 21

Control panel Desset Air 20:
A. On/Off button
B. Timer button
C. Fan speed button
D. Air humidity higher button
E. Air humidity lower button
F. Clean dryer button
1. Power lamp
2. Timer lamp
3. "Water reservoir full" lamp
4. "Fan low" lamp
5. "Fan high" lamp
6. "Clean dryer" lamp
7. Compressor lamp
Display
The display normally shows the air humidity in the space.
If you set a required humidity, it will show the set air humidity for a few seconds.
If you set a switching on or off time with the timer, the display will show the set number of
hour for a few seconds.
If the air humidity is less than 35%, it will show "LO" (low) and the device does not work.
If the air humidity is higher than 95%, it will show "HI" (high).
Initial operation
1. Insert the plug into an appropriate socket, in accordance with the specifications on the
type plate. Only connect the appliance to an earthed socket!
2. Press the ON/OFF button (A); you will hear the compressor and the fan start up (the
"comp" lamp c.q. the "power" lamp will now light up continuously). The appliance will
start working. The display will show the air humidity in the space. By pressing the
ON/OFF button again, you will switch the appliance off.
3. Using the "Higher" and "Lower" buttons (D&E), you can now set the required air
humidity between 30% and 90% (at intervals of 5%). The display will show the set air
humidity for a few seconds, afterwards the current air humidity will be shown. Once
the required level has been reached (± 2%), the compressor will stop, the fan
continues to run. The dehumidifier thus keeps the air in the room moving and is
therefore able to feel the humidity and to catch on again in time. If the air humidity
rises once more to more than 3% above the set value, the appliance will start again.
The compressor has a time lag of at least 3 minutes protection time between stopping
and starting.
If you set the air humidity with the "Lower" button to "Co", the appliance will operate
continuously.
21