Publicité
Les langues disponibles
Les langues disponibles
USE
Pan detection
If the hob does not detect a (ferrous) pan after the cooking power has been set, the pan
detection symbol and the selected power setting will flash alternately in the display and the hob
will remain cold. If a (ferrous) pan is not placed on the cooking zone within 1 minute, the cooking
zone will automatically switch off (see also chapter 'Pans').
Indications in the display
In display
Status
Power setting cooking zone; 1 = low setting / 9 = high setting
Boost function active
No (suitable) pan on cooking zone (pan detection symbol)
Residual heat indicator; The hob has a residual heat indicator for each cooking
zone to show those which are still hot. Although the hob is switched off, the
indicator 'H' will remain on for as long as the cooking zone is hot!
Avoid touching them when this indicator is lit. Danger! Risk of burns.
Pause function selected
Fault code; See 'Troubleshooting table'
Cooking-timer/alarm
•
A cooking-timer can be set for each active cooking zone.
•
The hob also has an alarm. Both the cooking-timer as well as the alarm can be set for a
maximum of 99 minutes.
•
The alarm works in the same way as the cooking-timer, but is not linked to a cooking zone.
If the alarm has been set, it will continue counting down after the hob has been
switched off.
•
The alarm can only be switched off when the hob is switched on.
Select the desired function:
•
Cooking-timer — the timer is linked to a active cooking zone. After the set time has
elapsed, the cooking zone will switch off automatically.
•
Alarm — the alarm only beeps after the set time has elapsed.
EN 10
Publicité
