Maintenance And Cleaning; Handling - Conrad 551319 Notice D'emploi

10. Maintenance and Cleaning

Servicing or repair must only be carried out by a specialist or specialist workshop. There are no components on the
inside of the product that need maintenance by you, this is why you should never open/disassemble it (apart from
the assembly and commissioning work described in these instructions).
A dry, soft and clean cloth is sufficient for cleaning the outside. Do not press on the display too much; this may cause
scratches or even break the display.
Dust can easily be removed with a long-hair, soft and clean brush and a vacuum cleaner.
Never use any aggressive cleaning agents, cleaning alcohol or other chemical solutions, since these may
damage the casing or even impair function.

11. Handling

• The operation of the two mains adapters and indoor unit is only admissible in dry rooms. There is danger
to life from electric shock otherwise!
• The outdoor unit is intended for operation in protected outdoor areas, e.g. under a roof projection.
• Servicing or repair must only be carried out by a specialist/specialist workshop.
• Check the product for damage before each use.
If there is any damage, the product must not be connected to mains voltage or switched on.
It can be assumed that safe operation is no longer possible if:
- the product is visibly damaged
- the product does not work properly or not at all anymore (e.g. smell of fire)
- the product was stored under unfavourable conditions
• When setting up the product, make sure that the cables are neither bent nor pinched. Place the cable
so that you cannot trip over it.
• The following unfavourable conditions are to be avoided at the place of installation or during transport:
- dampness or high humidity
- extreme cold or heat
- dust or flammable gases, fumes or solvents
- strong vibration
43