Submenu "Recorder Setup - Conrad 551319 Notice D'emploi

c) Submenu "Recorder Setup"
Use the buttons "/
formatting the SD memory card ("SD Card Format") and SD overwrite mode ("SD Card Overwrite").
Automatic recording on/off ("Visiting Record")
• Choose between "ON" (automatic recording on) and "OFF" (switched off) with the buttons " V-" (20) and " V+"
(22).
If automatic recording is activated, every push of the outdoor unit call button (4) will start recording (recording
duration max. 1 minute if not terminated before).
• Confirm your selection of "ON" or "OFF" by pressing the button "
• To leave the submenu, push the button "
Formatting the SD memory card ("SD Card Format")
• To format the SD memory card, push the button "
• A safety prompt appears. Use the buttons " V-" (20) and " V+" (22) to choose the symbol "X" (cancel, do not
format) or "O" (OK, format) and push the button "
If "0" is selected formatting starts and a rotating arrow symbol appears. Depending on memory card capacity,
formatting may take some seconds.
Attention!
Formatting the memory card deletes all data on it! In doubt, check, e.g., via a computer's card reader,
whether there are still any important data on the memory card.
• To leave the submenu, push the button "
SD overwrite mode on/off ("SD Card Overwrite")
• Choose between "ON" (overwrite mode on) and "OFF" (switched off) with the buttons " V-" (20) and " V+" (22).
• Confirm your selection of "ON" or "OFF" by pressing the button "
If overwrite mode is on, the respective oldest recordings are deleted when the SD memory card is full. If overwrite
mode is off, no additional recording is possible when the memory card is full. An error message appears. Transfer
the recordings to the memory card, e.g. to a computer and delete the memory card before using it in the indoor unit
again.
Alternatively, you may insert a new, empty memory card in the memory card insert of the indoor unit.
• To leave the submenu, push the button "
40
" (18) and "/ " (21) to choose between automatic recording ("Visiting Record"),
/ESC" (23).
/ESC" (23).
/ESC" (23).
" (19). The display briefly shows "OK".
OK
" (19).
OK
" (19).
OK
" (19). The display briefly shows "OK".
OK