Conrad 551319 Notice D'emploi page 32

• Use the included power connection cable (13) and
the mains adapter for an output voltage of 15 V/DC
to connect the power supply.
Connect the two open cable ends of the power
supply cable (13) to the clamps "DC +" and "DC -",
observe correct polarity.
DC + Red cable
DC- Black cable
Remember to push the cable through the rubber
seal to the cover.
• The two clamps "UNLOCK" are used to connect a common door opener with an operating voltage of 12 V/DC. If
a polarity is indicated on the door opener, it must be observed.
• Attach the cover to the back of the outdoor unit again.
• Insert the outdoor unit into the weather protection casing installed initially.
The scope of supply includes 2 special screws and a matching screwdriver. The special screws are used to attach
the outdoor unit in the weather protection casing.
• Connect the mains adapter to a mains socket. The outdoor unit is now ready for operation.

At night, the integrated IR-LEDs are switched on automatically. The IR light is not visible for the human
eye.
The image on the indoor unit screen is displayed in black and white only at night (when then IR-LEDs are
active) rather than in colour.
32