Husqvarna PG 510 Manuel D'utilisation page 13

1. Look at the arrow to see in which direction the motor
rotates.
2. Turn the 2 pins in the power plug in the opposite
direction to change in which direction the motor
rotates. This is only applicable for 3-phase.
1146 - 003 - 21.03.2024
To start the product
1. Push down the handle lightly to lift the grinding
head from the surface, approximately 1 mm. This
decreases the pressure against the surface. Do not
lift the grinding head fully from the surface.
2. Turn the ON/OFF switch to 1 to start the product. In
less than 5 seconds the product operates at the idle
speed.
To stop the product
CAUTION:
the surface when you stop the motor. The
tool plate rotates for a while after the motor
stops. Much off the dust can blow off in to
the air and the surface can be damaged.
CAUTION:
asphalt, paint or equivalent material, lift up
the front of the product slightly when the tool
plate stops. The product can attach to the
adhesive surface if not lifted.
1. Turn the ON/OFF switch to 0 to stop the motor.
Do not lift the tool plate from
If you grind adhesive
13