Publicité
Les langues disponibles
Les langues disponibles
■ The appliance should be installed far away from sources of heat such as
EN
radiators, boilers and direct sunlight. Ensure that air can circulate freely
around the back of the appliance. Ideally, the appliance should not be
positioned below any overhanging wall units. However, if it is placed under
an overhanging wall unit, make sure there is a clearance distance of at least
50 mm. Do not stack the appliance with other household appliances.
■ Accurate levelling is ensured by one or more of the adjustable feet at the
base of the appliance.
■ This appliance is not intended to be used as a built-in appliance.
Electrical Connection
■ Before plugging the appliance in, ensure that the voltage and frequency
shown on the rating plate corresponds with your domestic power supply.
The appliance must be grounded/earthed. The power supply cord plug is
provided with a contact for this purpose. If the domestic power supply socket
is not grounded, connect the appliance to a separate earth in compliance
with current regulations. Consult a qualified electrician.
■ The manufacturer declines all responsibility if the above safety precautions
are not observed.
■ This appliance complies with the E.E.C. Directives.
Levelling the Appliance
■ Level the appliance using the two adjustable front feet which can be screwed
or unscrewed to change the height. See Figure 2.
NOTE: If the appliance is not level and in firm contact with the floor, the doors
and the magnetic seal alignment will not be covered correctly. An unlevel
appliance can lead to excessive noise and vibration.
REVERSING THE DOOR OPENING DIRECTION
Before reversing the doors, prepare the following tools and components:
1. Flat bladed screwdriver x 1
2. Philips screwdriver x 1
3. Spanner x 1
4. The left aid-closer in the accessory bag
Notes:
■ Ensure the appliance is unplugged and empty.
■ To remove the door, it is necessary to tip the appliance backwards. Rest the
appliance on something solid so that it will not slip during the door reversal
process.
8
Publicité
