TEMPUR-PEDIC TEMPUR ERGO PROSMART AIR Manuel Du Propriétaire page 20

remote control
MISC. FAN MODES
Split Fan Mode
This mode applies to TXL and CKS sizes only
that have already been wirelessly sync'd using
the Sync buttons on the back of the remote
controls. Then, using the remote control from
the Left side base, press and hold the Left
Heating button and Sync Cooling button
for 6 seconds. After 6 seconds, the remote
backlight should blink 2X indicating the bases
are now in Split Fan Mode. In Split Fan Mode,
the fan buttons on both remote controls will
operate the fans as follows:
To deactivate Split Fan Mode: Use the remote
control from either base to press and hold the
Right Heating button and Sync Cooling button
for 6 seconds. After 6 seconds, the remote
backlight should blink 2X indicating the bases
are no longer in Split Fan Mode. When Split
Fan Mode is deactivated, the fan buttons on
both remote controls will revert back to the
default state where all fan buttons control all
fans on sync'd bases.
16
• Left side fan buttons will control fans on
Left side base.
• Right side fan buttons will control fans on
Right side base.
• Sync fan buttons will control fans on both
Left and Right side bases together.
Retail Demo Mode
Press and hold the LEFT and RIGHT cooling
buttons simultaneously for 3 seconds, after
which which all fan LEDs should blink blue
3X indicating Retail Demo mode is active.
Fan intensity and duration should follow
Retail Demo Mode section on Fan modes
tab.
To deactivate Retail Demo Mode: Press any
of the Fan Cooling or Heating buttons.