Publicité
Les langues disponibles
Les langues disponibles
Maintenance
Clean or replace the spark arrestor mesh on the muffler (only applies to
mufflers without a catalytic converter).
Do a check of the fuel filter for contamination and the fuel hose for cracks
or other damages (130L (LT13028CSHV). Replace if neccessary.
Do a check of all cables and connections.
Do a check of the clutch, clutch springs and the clutch drum for wear.
Replace if neccessary by an authorized service workshop.
Replace the spark plug. Make sure that the spark plug is fitted with a
suppressor.
Check and clean the spark arrestor mesh on the muffler (only applies to
mufflers without a catalytic converter).
The engine does not start
Check
Starter pawls.
Fuel tank.
Spark plug.
The engine starts but stops again
Check
Fuel tank.
Air filter.
1687 - 004 - 05.09.2023
Troubleshooting
Possible cause
The starter pawls cannot move freely.
Incorrect fuel type.
The spark plug is dirty or wet.
The spark plug electrode gap is incorrect.
The spark plug is loose.
Possible cause
Incorrect fuel type.
The air filter is clogged.
Daily
Procedure
Remove the starter cover and clean
around the starter pawls.
Let an approved service agent help you.
Drain the fuel tank and fill with correct
fuel.
Make sure that the spark plug is dry and
clean.
Clean the spark plug. Make sure that the
electrode gap is correct. Make sure that
the spark plug has a supressor.
Refer to technical data for correct elec-
trode gap.
Tighten the spark plug.
Procedure
Empty the fuel tank and fill it with
correct fuel.
Clean the air filter.
Weekly
Monthly
X
X
X
X
X
X
21
Publicité
