Publicité
Les langues disponibles
Les langues disponibles
•
If the spark plug is dirty, clean it and make
sure that the electrode gap is correct, refer to
Technical data on page 22 . (Fig. 67)
•
Replace the spark plug if it is necessary.
Air filter
Remove dust and dirt from the air filter to keep it
clean and prevent these problems:
•
Carburetor malfunctions.
•
Problems when you start the product.
•
Loss of engine power.
•
Increased wear to engine parts.
•
Too much fuel consumption.
To clean the air filter
1. Remove the air filter cover and remove the filter.
2. Hit the filter against a flat surface to make the
particles fall off.
CAUTION:
or compressed air to clean the air
filter.
3. Put the air filter back. Make sure that the air filter
fully seals against the air filter holder.
Maintenance
Clean the external surface.
Make sure that the throttle trigger lock and the throttle works correctly from
a safety point of view.
Do a check of the stop switch to make sure that it works correctly.
Make sure that the cutting attachment does not rotate at idle speed.
Clean the air filter. Replace if necessary.
Examine the cutting attachment guard for damages and cracks. Replace
the guard if it has been exposed to impact or is cracked.
Examine the trimmer head for damages and cracks. Replace if damaged.
Make sure that the screws and nuts are tight.
Examine the engine, the fuel tank and the fuel lines for leaks.
Clean the cooling system.
Examine the starter and the starter rope for damages.
Examine the vibration damping elements for damages and cracks.
Clean the outside of the spark plug. Remove it and do a check of the
electrode gap. Adjust the gap to the correct distance (refer to
the spark plug on page 19 ) or replace the spark plug. Make sure that the
spark plug is fitted with a suppressor.
Clean the outside of the carburettor and the space around it.
Do a check of the bevel gear to make sure that it is filled three-quarters with
lubricant. Use special grease to fill if necessary.
20
Do not use solvent
4. Put the air filter cover back.
Note:
An air filter that is used for a long time
cannot be fully cleaned. Replace the air filter at
regular intervals. Always replace a damaged air
filter.
Bevel gear 130L
The bevel gear is filled with the right quantity of
grease at the factory. But, before you use the
product, make sure that the bevel gear is 3/4 full with
grease. Use Husqvarna special grease.
(Fig. 68)
The grease in the bevel gear does not need to be
changed unless repairs are carried out.
Maintenance schedule
The following is a list of the maintenance steps that
must be performed on the product. Most of the items
Maintenance on page 19
are described in
Note:
The user must only carry out the
maintenance and service work described in this
operator's manual. More extensive work must be
carried out by an authorized service workshop.
To examine
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
1687 - 004 - 05.09.2023
Publicité
