Domo DO433K Mode D'emploi page 29

bEFORE FIRST USE
• Check if all accessories are included and if the appliance is not damaged.
• First let water run through the appliance, without adding coffee. To do so, fill the
waterreservoir up to the maximum level, switch on the coffee maker and let the
water run through completely for about one or two times. afterwards, dispose of
the water and clean the filter, carafe and lid of the carafe thoroughly with warm
water.
MAkING COFFEE
1. Open the top cover of the coffee maker and fill the water tank by using the carafe.
the amount of water should not exceed the maximum indication.
2. Put a paper filter into the filter holder
3. Pour the preferenced amount of coffee into the paper filter.
4. insert the glass carafe horizontally into the coffee maker. put it on to the keep
warm plate, under the drip stop.
5. plug the power cord into the outlet and push the on/off switch. the red indicator
will light up and the coffee maker will start brewing.
You can remove the carafe from the coffee maker at any chosen time to
pour coffee. the appliance will stop dripping automatically during 30
seconds.
6. the coffee is ready about one minute after the coffee stops dripping from the
appliance.
• The final amount of coffee will always be a little less than the amount of
water you put in, because the coffee absorbs water.
• Be careful while pouring, the coffee is hot right after brewing.
• for safety reasons it is considered wise to keep the lid on the carafe.
this way the coffee also stays warm.
7. When the brewing process has come to an end and you do not want to serve the
coffee right away, leave the on/off switch on. this way the keep warm plate keeps
the coffee warm until the appliance is turned off. to maintain an optimal coffee
taste, it is best to serve the coffee right after brewing.
8. always turn off the coffee maker and unplug the power cord from the outlet when
it is not in use.
29
DO433K