Makita BHR261 Manuel D'instruction page 7

Side grip (auxiliary handle)
1
2
6
4
3
5
009673
CAUTION:
Always use the side grip to ensure operating
•
safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck
lubrication assures smooth action and longer service
life.
Installing or removing the bit
Clean the bit shank and apply bit grease before installing
the bit.
1
009664
Insert the bit into the tool. Turn the bit and push it in until
it engages.
1
2
009674
If the bit cannot be pushed in, remove the bit. Pull the
chuck cover down a couple of times. Then insert the bit
again. Turn the bit and push it in until it engages.
1. Grip base
2. Teeth
3. Loosen
4. Tighten
5. Side grip
6. Protrusion
1. Bit shank
2. Bit grease
2
1. Bit
2. Chuck cover
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
009675
Bit angle (when chipping, scaling or
demolishing)
009676
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
009677
7
1. Bit
2. Chuck cover
1. O symbol
2. Action mode
changing knob
1
2
symbol. Then make sure that the