LENCO MC-660 Mode D'emploi page 29

Press the button on the remote control to skip backward or forward to the desired
track.
Press the < button to entry the CD list.
Note: You can also play mp3 files from CD.
Bluetooth
Press the menu button on the Device or on the remote control and select the Bluetooth
mode
Make sure that no other Bluetooth device is connected to the MC-460 / MC-660. ("No
Connection "will show on the display). When a device is connected already, press and hold
the 'enter' button to enter the pairing mode
Activate Bluetooth mode on the device that you want to connect with. Scan for new devices.
(refer to the instruction manual of the device how to scan for new devices). The Lenco will
appear as "Lenco MC-460 / Lenco MC-660"on the Bluetooth device list.
Select the "Lenco MC-460 / Lenco MC-660"from the list. If you are required to enter a PIN
code, enter 0000 (four zeros). Certain devices may also require you to approve the
connection.
Once the connection has been successful, "Connected" will appear on the display.
To disconnect a connected Bluetooth device: Press and hold down the [Enter] button for
3 seconds. The message "No Connection" will appear on the display.
Start playback on your Bluetooth device:
Control the playback from the Bluetooth device or from the radio using the Vol+/Vol- on the
device and remote control, Adjust the volume both on the Bluetooth device and the radio.
Press and hold the <" and „>" to skip backward or forward to the desired track .
Press the button on the remote control to skip backward or forward to the desired
track.
Press the "enter" button to pause/play the current track
29