Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
3. Use a pipe vise to prevent the pump and pipe
from dropping into the well. (Fig 3)
4. Add a well seal or pitless adaptor to allow for the
pipe to be connected to house service. (Fig. 4)
4a. Pitless Adaptor Installation. Pitless adaptor
should be installed below the frost line, and on
the side of the well casing where the supply
line will run from well, in accordance with the
manufacturer's instructions. (Fig. 4a)
NOTE: Pitless adaptor models vary according to
each application.
4b. Well Seal Installation: After the pump assembly
is lowered into the well, mount the well seal
onto the well casing and tighten the four bolts in
the well seal evenly. (Fig. 4b)
3
4
4a
4b
9
Copyright © 2023 Flint & Walling. All rights reserved.
Well Seal
Installation
At Top of
Well Casing
Adaptor
OR
Installation
Frost Line
Pitless
Below
IL1148
Publicité
