Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL HOOKUP FROM THE HOUSE TO PUMP AND PRESSURE TANK
6. Thread the electrical wire from the pressure
switch into the left opening at the bottom of the
control box and tighten the electric wire strain
relief securely. (Fig. 6)
7. Connect the two wires from the pressure switch
to the terminals in the control box marked L1 and
L2. (Fig. 7)
8. Connect the green ground wire from the pressure
switch to the green ground screw in the lower left
corner of the control box and re-install the control
box cover. (Fig. 8)
9. Remove cover from pressure switch and screw
the switch into the 1/4 in. opening on the top of
the pipe tee. (Fig. 9)
6
7
8
9
17
Copyright © 2023 Flint & Walling. All rights reserved.
L1
L2
R
L1
L2
R
Y
B
IL1178
L1
L2
R
Y
B
IL1177
L1
L2
R
Y
B
IL1179
Y
B
IL1180
Publicité
