Publicité
Les langues disponibles
Les langues disponibles
SAFETY INFORMATION
Follow all local electrical and safety codes, as well
as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
This product contains chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm.
Wire motor for correct voltage. See Electrical section
and motor nameplate.
Ground motor and controls before connecting to
power supply.
Follow wiring instructions in this manual when
connecting to power lines.
Protect power cable from nicks or cuts from sharp
objects or scraping on well casing when lowering
pump into well. Do not allow it to come into contact
with oil, grease, hot surfaces or chemicals.
The motor voltage and phase indicated on the motor
nameplate should be checked against the actual
electrical supply. Check your power source. Check
electrical supply for correct fusing, wire size, and
adequate grounding and transformer size.
NOTE: Install all electrical equipment in protected area to provide adequate ventilation for pressure switch and
controls to prevent moisture damage to components.
NOTE: Install pump, pressure tank, pitless adaptor or well seal in accordance with state and local plumbing
codes.
WARNING
Do not use to pump flammable or explosive fluids
such as gasoline, fuel oil, kerosene, etc. Do not use
in flammable and/or explosive atmospheres.
Install pressure relief valve in discharge pipe.
Release all pressure on system before working on
any component.
CAUTION
The power supply for a submersible pump should be
a separate circuit, independent of all other circuits. It
must be equipped with a fuse box of ample capacity.
Shut off power source when voltage drops 10% below
rated voltage of motor.
For fire protection, power supply should be free of any
building, preferably on a direct line from transformer.
In event of fire, wires will not be destroyed and water
supply not cut-off.
2
Copyright © 2023 Flint & Walling. All rights reserved.
Publicité
