Zanussi ZBB 6254 Mode D'emploi page 64

Remove the brackets and mark a distance of 8 mm
8mm
from the outer edge of the door where the nail must
be fitted (K).
K
Ha
Place the small square on the guide again and fix it
with the screws supplied.
Should the lining up of the furniture door be
necessary, use the clearance of slots.
At the end of operations, it is necessary to check if
the door of the furniture closes properly.
Hb
PR168
Fix cover (Hd) on guide (Hb) until it clips into place.
Hb
Hd
PR167/1
If the appliance is to be fitted laterally to the kitchen
D
unit, it will be sufficient to loosen the screws of the
E
little plates (D), move them as shown in Fig. and
then fasten them up again. Fit the cover (E).
D734
64