Charging the batteries
Before using the walkie−talkies for the first time, place them in the charging station for at
least 14 hours. When the walkie−talkies are inserted correctly in the charging station, the red
LEDs light up. They only signal that the connection is correct and continue to light up even
when the battery packs are fully charged.
Do not charge the walkie−talkies with charging units from other
manufacturers.
The current battery charge status is indicated in the display:
Full
The battery pack needs to be recharged as soon as the indicator flashes in the display and
acoustic warning signals are issued.
Energy−save mode
Your walkie−talkies are provided with an energy−save mode to increase the service life of the
batteries. If no buttons on the walkie−talkies are pressed for a period of 5 seconds,
energy−save mode is activated. Energy−save mode is deactivated as soon as you press a
button or a signal is received.
Attaching the belt clips
Insert the belt clip in the opening provided until it audibly snaps into place. To remove the
belt clip, press on it and pull it from the opening.
Preparing the Walkie−Talkies for Use
Half empty
B
Low
Empty
51