Franke FSL 86 H Manuel De L'utilisateur page 11

REPLACING THE LAMP
1. Disconnect the oven from the power supply�
2. Remove the cover from the light, replace the bulb
and put the cover back on the light�
3. Reconnect the oven to the power supply�
TROUBLESHOOTING
Problem
The oven does not work�
SUPPORT
In the event of any operation problems, contact a Franke
Technical Service Centre�
Never use the services of unauthorized technicians�
Specify:
- the type of fault
- the appliance model (art�/Code)
- the serial number (S�N�) on the rating plate, located
on the right hand edge of the oven cavity (visible
when the oven door is open)�
001
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
Possible cause
Power cut�
Disconnection from the
mains�
When contacting our
Service Centre, please
state the codes provided
on your product's
identification plate�
Solution
Check for the presence of mains electrical
power and whether the oven is connected to
the electricity supply�
Turn off the oven and restart it to see if the
fault persists�
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXXXXXXXXX
XXX X X X X X XXX XX XXXX X X X
EN
XXXXXX XXXXXX XXXXX XXXXXXX
Model: xxxXXXXxx
XXXXXX
11