Publicité
Les langues disponibles
Les langues disponibles
9.
ASSEMBLY INSTRUCTIONS
9.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.
10. MOUNTING INSTRUCTIONS
Mounting the charger to the fender well:
The charger can be mounted directly to the fender well of
your vehicle, as shown, using the double-sided adhesive
and cable tie (included).
Mounting the charger alongside the battery:
The charger can also be mounted alongside your vehicle's
battery, using the bracket (sold separately). If possible, mount the charger to the
side of the battery away from the engine and fan blades. Mount the bracket to the
charger as shown using the nuts and bolts provided with the bracket. Loosen the
battery retaining hardware enough that you can insert the bracket between the
bottom of the battery and the battery mounting tray as shown. Position the charger
so that it will not rub against the battery or any other part of the vehicle, and then
tighten the battery retaining hardware. NOTE: Do not drill or
puncture the battery.
Electrical Installation:
The output leads of the charger
are terminated with 3/8˝ dia. ring
lugs. Route and secure the AC
cord and the output wiring away
from the gas line, carburetor or
other hot, sharp, moving or pinch parts to avoid damage to the insulation. Secure
the AC cord using a cable tie or equivalent. If you have difficulty connecting the
output leads, consult your local auto supply store, they may assist you in finding a
connecting device for your application.
11. LED INDICATORS
RED LED (solid): The charger is charging the battery.
RED LED (flashing): The connections are reversed, or the battery is bad.
GREEN LED (solid): The battery is fully charged and the charger is in maintain mode.
NOTE: See Operating Instructions for a complete description of the charger modes.
• 9 •
Publicité
