Eneo PXB-2080MIR D Guide D'installation Rapide page 23

• Turn the Focus gear to "N" (Near) or "∞" (Far) until the sharpest focus is made.
• To widen the viewing angle, turn the Zoom to "W" (Wide) and to obtain a closer
view, turn it to "T" (Tele)
Power supply connections
Make sure the power is removed before the installation. Camera can work with either
24VAC or 12VDC, dual voltage power and PoE (IEEE Std. 802.3af ). Primary and secondary
grounds are completely isolated to avoid the possible ground loop problems.
1. Plug the network cable into RJ-45 Ethernet Port. If PoE is the unique power, there
will be no need to connect Power terminal.
2. b) When DC12V or AC24V Local power is necessary, connect the low voltage
(DC12V or AC24V) first, then plug the AC adapter to AC outlets to avoid an
improper reset from power jitter and a damage from the surge voltage when no
load.
When PoE and local dual power are connected at the same time, local power has
i
priority.
Attach the Signal Assignment Sticker in a visible spot for wiring reference.
AC24V/DC12V (Red wire)
AC24V/GND (Black wire)
Alarm-IN (Green wire)
Alarm-OUT (Blue wire)
GND (Gray wire)
Audio-IN (Brown wire)
GND (Gray wire)
Audio-OUT (Orange wire)
EN
23