Publicité
Les langues disponibles
Les langues disponibles
Installation instructions
CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed.
2. Place the easy bracket on pre-drilled position and fix it through using mounting
screws(4x30mm). Skip this step when an easy bracket is not installed.
3. Route the ethernet and power cable to the connecting place. Hook up the camera
bracket with the easy bracket as illustrated below.
4. Fix the camera bracket through using assembly screws (4x14mm).
5. Set the camera's viewing angle and adjust zoom/focus of lens by using the torque
wrench..
6. Put the sunshield to the camera unit and tighten the sunshield-bolts.
20
The easy bracket can not be installed on the ceiling.
i
Publicité
