Lovibond Tintometer TC Serie Mode D'emploi page 9

Setting up
• Do not place the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal
and level. Compensate for uneven floors with the adjustable feet.
• Do not cover ventilation openings or grille.
• Always install the appliance directly against
the wall.
• Standard EN 378 specifies that the room in
which you install your appliance must have
a volume of 1 m per 8 g of R 600a refriger-
3
ant used in the appliance, so as to avoid the
formation of inflammable gas/air mixtures in
the room where the appliance is located in
the event of a leak in the refrigerant circuit.
The quantity of refrigerant used in your appliance is indicated
on the type plate on the inside of the appliance.
Important
When unpacking and setting up use protective gloves.
Appliance dimensions
A B
850 mm 600 mm
Installing beneath a worktop
For continuous worktops the refrigerator's tabletop can be detached.
The refrigerator can then be pushed under the existing worktop.
• To take off tabletop remove screws ➊.
• A cross-section of min. 200 cm
for ventilation of the rear of the appliance.
TC 135 S / TC 140 G_6 02/2024
C D E
600 mm 648 mm 1153 mm
is re quired in the worktop
2
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type plate.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appliance and
must be easily accessible.
Do not connect the appliance using an extension cable or exten-
sion socket.
Do not use stand-alone inverters (conversion of
direct current to alternating current/three-phase
current) or energy-saving plugs. Risk of damage
to the electronic control system!
Safety lock
The lock in the appliance door is equipped with a safety mechanism.
Locking the appliance
• Insert the key as shown by
arrow 1.
• Turn the key 90°.
To unlock the appliance, the
same procedure must be re-
peated in the same order.
Loading
Important
The maximum load per grid shelf is 45 kg.
Interior lighting
TC 140 G
The interior is illuminated by an LED light strip.The light intensity
corresponds to laser class 1/1M.
Attention
The light cover may only be removed by the customer service. When
the cover is removed, do not look directly into the lighting with
optical lenses at close range. This may damage the eyes.
GB
9