Publicité
Les langues disponibles
Les langues disponibles
INSTALLING A UNIT WITH A TECHNICAL DOOR
1) Level the unit inside the cabinet.
2) Open the door of the unit at a 90¡ angle.
1- Drawing for unit placed on the floor
5 - Putting into service - Temperature settings
- After 48 hours, Turn the On/Off switch (I/O) on the right of the control panel to the On position (I).
The green cold circuit On indicator light will light up if the temperature is set at below ambient temperature
single-temperature Veillith•que and located in an area where the temperature is below 12¡C).
In the event of an anomaly, refer to Section 8.
3) Fix the facing of the kitchen cabinet on the door of the unit
(8 screws included).
4) Be sure the gasket seals properly.
2- Drawing for unit placed in a cabinet
- 7 -
A mini (mm)
A mini (mm)
Models
legs screwed in
legs unscrewed
836
852
056
156
1236
1252
1796
1812
256
Nota :
A = Body + Hinge (25mm) + Pedestal (92.5mm) + Legs (19 ˆ 35mm).
(unless your cabinet is a
B mini
(mm)
841
1241
1801
Publicité
